Table of Contents
Advertisement
To delete all IP addresses from an interface, enter the following command:
PowerConnect(config-if-1/1/1)# no ip address *
Syntax: no ip address <ip-addr> | *
Connecting network devices
Dell devices support connections to other vendors' routers, switches, and hubs, as well other Dell
devices.
Connectors.
For port pinouts, refer to
Cable specifications
Refer to
Connecting to Ethernet or fast Ethernet hubs
For copper connections to Ethernet hubs, a 10/100BaseTX or 1000BaseT switch, or another Dell
device, a crossover cable is required
uplink port, it will require a straight-through cable instead of a crossover cable.
NOTE
The 802.3ab standard (automatic MDI or MDIX detection) calls for automatic negotiation of the
connection between two 1000Base-T ports. In this case a straight-through cable may work just as
well as a crossover cable. For more information about this feature, see the PowerConnect B-FCX
Series Configuration Guide.
FIGURE 32
PowerConnect B-FCX Switch Hardware Installation Guide
53-1002267-01
"Pinouts and signalling"
"Cable specifications"
on page 62 for cable lengths and types.
UTP crossover cable
1
2
End A
3
4
5
6
7
8
on page 61.
(Figure 32
and
Figure
10/100BASE-TX Crossover Cable
White/Orange Stripe
Orange
White/Green Stripe
Blue
White/Blue Stripe
Green
White/Brown Stripe
Brown
Configuring IP addresses
33). If the hub is equipped with an
1
2
3
4
5
6
7
8
3
End B
39
Advertisement
Table of Contents
Troubleshooting
