Access The Console Ports; Access The Rj-45 Console Port (Rs-232) - Dell S60 System Manual

Access the Console Ports

You can access the S60 system directly through the console port at rear of the system

Access the RJ-45 Console Port (RS-232)

NOTE: Before starting this procedure, be sure you have a terminal emulation program already installed on
your PC.
The RS-232 console port is labeled on the upper right-hand side on the rear of the S60 system.
Figure 6-1. S60 Serial Console Port Connector
For the console port pin assignments, refer to
To access the RJ-45 console port, follow these steps:.
Step Task
Install an RJ-45 copper cable into the console port. Use a rollover cable to connect the S60 console port to a
1
terminal server.
Connect the other end of the cable to the DTE terminal server.
2
Set the default terminal settings as follows:
3
• 9600 baud rate
• No parity
• 8 data bits
• 1 stop bit
• No flow control
Console
Port
Table 6-1.
6
(Figure 6-1).
Access the Console Ports | 28