Table of Contents
Advertisement
Figure 21. Inserting the First RPM in the Chassis
4.
Push in the levers until the thumb tabs pop up and the card is fully inserted in the slot. The ejector
levers hide under the card.
5.
If the C9010 uses two RPMs, insert the second RPM into RPM slot 1 below the first RPM by following
Steps 1 to 4.
6.
If the C9010 uses only one RPM, install a blank panel to cover RPM slot 1. Secure the panel with the
screws provided.
Installing a Line Card
Install the fan trays before you install line cards in a C9010 switch.
Before you install line cards, review these guidelines:
•
On the C9010, line-card slots are labeled 0 to 9. You can insert any linecard into any line-card slot.
Refer to
C9010 Hardware Description
•
To control airflow for adequate system cooling, personal safety, and EMI containment during
operation, install blanks in any empty line-card slots. Install operational modules or blanks in all line-
card slots. Always replace cards and blank panels immediately.
Installing the Hardware
for the location of line-card slot numbers.
27
Advertisement
Table of Contents
