Moving Outlines - Brother PE-Design 8.0 Instruction Manual

Step 3 Figure Handle Stage
Points in the figure handle image can be moved,
added or deleted to change the design.
Sewing attributes cannot be applied to regions if the
region is not completely enclosed in an outline. In
this stage, fully enclose areas to be sewn as
regions.
■

Moving outlines

1
Click , and then click the outline to be
moved.
→ Handles appear, and the outline appears
in red.
2
Move the pointer over the outline so that the
shape of the pointer changes to
drag the outline.
148
Basic Design Center Operations
, and then
Handle
■
Adding lines to the figure handle
image
1
Click on the Tool Box.
2
Click in the Design Page to specify the start
point, and then click in the Design Page to
specify the next point.
→ A line is drawn connecting the two points.
Continue clicking to draw additional lines.
b
Memo:
• To remove the last point that was entered,
right-click.
• To draw vertical or horizontal lines, hold
down the Shift
pointer.
3
Double-click the end point.
key while moving the