Hooping The Fabric - Brother PE-Design 8.0 Instruction Manual

4
Place the template on the fabric, and mark
points A, B, C and D.
A
D
5
To mark an area to the right of the previously
marked area, align points A and D on the
template with marks B and C on the fabric.
A A
D D
6
To mark an area below the previously marked
area, align points A and B on the template with
marks C and D on the fabric.
A
A
D
D
7
Repeat steps 4 through 6 to reposition the
template and draw the embroidering position
for each section of the embroidery pattern.
Tutorial (Advanced)
B
C
B B
C C
B
B
C
C
a
Note:
• The intersection of the horizontal and
vertical line indicates the center of the
embroidery hoop.
• While carefully considering how the fabric
will be hooped, place the template on the
fabric, and then draw lines to indicate the
embroidering position. In addition, because
all embroidery areas are not drawn on the
template for large embroidery hoops, be
careful that the embroidery area does not
extend from the marked area on the fabric as
shown below.
Step 6

Hooping the fabric

Using the hoop's plastic embroidery sheet, align the
reference lines on the embroidery sheet with the marks
on the fabric. Then, hoop the fabric while making sure
that the fabric remains correctly aligned.
1
Insert the embroidery sheet into the inner ring
of the embroidery hoop, and then place them
on top of the fabric with the centerline on the
embroidery sheet aligned with the reference
lines (drawn on the fabric) for the first pattern
section to be sewn.
179