Using The Sewing Attributes Bar; Line Sewing - Brother PE-Design 8.0 Instruction Manual

Manually Creating Embroidery Patterns From Images (Design Center)
b
Memo:
• Although a region may seem closed, if the
sewing attributes cannot be specified for the
region, the region may not actually be
closed. To find the opening in the region,
use the line drawing mode in the Figure
Handle Stage to divide the region into
smaller regions, and then check which
region sewing attributes cannot be applied
to in the Sew Setting Stage.
• Point edit mode is useful for closing regions.
• After sewing attributes have been specified,
right-clicking an area where settings have
been specified displays the Sewing
Attribute Setting dialog box so that
detailed sewing attribute settings can be
viewed.
■

Line sewing

1.
Click or
2.
If necessary, change the color and sew type.
c
"Using the sewing attributes bar" on
page 164.
3.
Click the outline to apply the sewing attributes.
→ "Marching lines" appears along the
selected outline, and the color and sew
type selected on the Sewing Attributes
bar are applied to the outline.
164
on the Tool Box.
b
Memo:
• When on the Tool Box is selected,
settings are applied only to a portion of the
clicked outline.
• After sewing attributes have been specified,
right-clicking a line where settings have
been specified displays the Sewing
Attribute Setting dialog box so that
detailed sewing attribute settings can be
viewed.
Using the sewing attributes
bar
The Sewing Attributes bar, available in the Sew
Setting Stage, allows you to set the color and sew
type of region and outlines.
The sewing attributes that are available depend on
the tool selected in the Tool Box.
Example 1: When
Example 2: When
selected
Region sew: Switches on/off
sewing for the region.
Line sew: Switches on/off
sewing for the line.
Region color, Line color:
Click this button to set the
thread color for lines or regions.
Region sew type, Line sew
type: Use these selectors to set
the sew type for lines or regions.
on the Tool Box is selected
or on the Tool Box is