Brother PE-Design 8.0 Instruction Manual page 106

Arranging Embroidery Designs (Layout & Editing)
Programmable fill
1
2
Direction
row
Offset
column
Base Sewing
Stitch Type
Step Pitch
Frequency
Pattern
Area where the embossing
or engraving effects are
applied
104
Select a pattern for the programmable fill stitch.
Click to display the Browse dialog box. Select a folder, and then select the desired
pattern (.pas file) from the list of patterns that appears.
Specify the pattern size. The pattern can
be enlarged or reduced while maintaining
the width-to-height proportion.
1 Height
Specify the pattern
(vertical
height.
length)
2 Width
Specify the pattern
(horizontal
width.
length)
Drag or select a value to specify the
angle of the pattern.
Specify the offset (shift) direction of the
pattern alignment.
Specify the offset (shift) amount of the
pattern alignment.
To specify base stitching, select the check box, and then specify settings for the following
attributes.
Specify the shape of the returning ends
of the stitching.
This cannot be specified if the sewing
direction is set to variable.
Specify the stitching pitch (length of one
stitch).
Specify the shift in the stitches.
Smaller
Short
Short
135°
180°
225°
0%
Row 50%
Short
0%
This area is sewn with the stitching settings
specified for the base sewing of the
programmable fill stitch.
This area is sewn with the stitching settings
specified by the pattern file.
Larger
Tall
Long
90°
45°
0°
315°
270°
Column 50%
Long
50%