Cisco NSS2000 - Gigabit Storage System Chassis Administration Manual page 98

Setting up End-User Access
Creating a Network Filter
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business NSS2000 Series Administration Guide
To add a network filter:
From the Manager Menu, click Access
The Network Filters page appears.
From the New Network Access Filter table, type the IP/MAC address to which you
are applying the filter, in the IP/MAC address field. You can also enter addresses
for the following:
•
An IP Address Range: Type the range according to the following format:
address-last address
first, followed by a hyphen, and then the last IP address in the range.)
•
A Subnet: Enter the subnet to set a filter for all the addresses within the
subnet. The format should appear as shown in the following example:
192. 1 68. 1 .0/24 (where the digits following the slash represent the number of
bits in the network portion of the IP address).
From the Filter drop-down menu, select the type of filter you want to apply to the
IP/MAC address.
Click Add.
Any connections that apply to the new filter rule are affected by the rule during
the next connection attempt.
Network.
. (Where the first IP address in the range is entered
5
first
90