Lan Led (Front Panel); Hard Disk Drive Leds (Front Panel) - Cisco NSS2000 - Gigabit Storage System Chassis Administration Manual

Troubleshooting
Cisco Small Business NSS2000 Series Administration Guide
•
To reset the box: Press and hold the Reset button while the system is
running until the Power LED begins to blink green. Release the Reset button.

LAN LED (Front Panel)

Solid Green: The LAN link is up and running at 1000 link speed, but is currently idle.
Flickering Green: The LAN link is up and running at 1000 link speed and is currently
active. The LED flickers off with activity.
Solid Yellow: The LAN link is up and running at 10/100 link speed, but is currently
idle.
Flickering Yellow: The LAN link is up and running at 10/100 link speed and is
currently active. The LED flickers off with activity.
Off: No LAN link is detected.

Hard Disk Drive LEDs (Front Panel)

The ACT and Error LEDs associated with each of the installed disk drives indicate
disk-drive activity, or an error condition.
The various states of the ACT LED indicates the drive activity:
•
Solid Green: The disk drive is configured but is currently idle.
•
Flicker Green: The disk drive is configured, active, and not rebuilding.
Flickers off with activity.
•
Blinking Green: The disk drive is configured and a RAID array is currently
rebuilding to the disk drive.
•
Off: The disk drive is not configured (not part of a RAID or JBOD array and
not exported).
The various states of the Error LED indicate that the disk drive is in an error
condition:
•
Solid Red: The disk drive is in a failed state.
•
Blinking Red: The disk drive is predicated to fail (via S.M.A.R.T.). We
recommend that you replace the disk drive to avoid the loss of data.
•
Off: The drive is OK.
A
150