Cisco NSS2000 - Gigabit Storage System Chassis Administration Manual page 31

Adding the NSS to your Network
Allowing a VLAN Access to the NSS
STEP 3
STEP 4
STEP 5
Cisco Small Business NSS2000 Series Administration Guide
•
Link: This shows as "1" for the Ethernet link.
•
VLAN: Enter the ID of the VLAN as it is defined within your network. The
range of valid VLAN IDs is from 1 to 4095.
•
Priority: Select the QoS priority for the VLAN traffic as it is defined for your
network. Valid options range from 0 to 7 (as defined by the IEEE 802. 1 p
standard). VLAN Ethernet frames contain a three-bit priority tag ranging
from 0 to 7 (where 0 is best effort and 7 is network-critical traffic).
•
Label: Enter a text description for the VLAN (for example, "Data", "Voice",
"Video", etc.). It can be made up of alphanumeric characters. Note that this
description is used solely as a reference within the NSS interface and does
not affect its operation.
Click Add.
The newly added VLAN appears in the VLAN Configuration table. A message
appears to advise that the VLAN does not take effect until you configure the IP
address.
Click OK.
The Network IP page appears. The newly added VLAN appears in the list.
Click Edit for the VLAN you need to configure.
The Network Configuration page appears.
3
23