Configuring Snmp Alerts - Cisco NSS2000 - Gigabit Storage System Chassis Administration Manual

Maintaining the NSS

Configuring SNMP Alerts

Configuring SNMP Alerts
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco Small Business NSS2000 Series Administration Guide
The NSS can send SNMP traps to alert you of various system events. If you
download and install the NSS's SNMP MIB, you get a more human readable
version of alerts displayed on your SNMP management station.
To define SNMP Trapsinks:
From the Manager Menu, click Admin
The SNMP Trapsinks page appears.
To install the NSS MIB on your management station, click Download.
Save and install the MIB to your management station. For more information on
installing and integrating the NSS MIB into your management station, refer to the
management station documentation.
Enter the IP address or hostname for the management station to which you want to
send the alerts.
Select the checkbox for each type of trap sink for which you want to send alerts to
the SNMP server. You can set up an alert for any of the following:
•
Disk: When the following occurs: 1) a drive is predicted to fail by S.M.A.R.T.,
2) a drive fails, 3) a drive is above temperature threshold, 4) a volume is
more than 90% full.
•
RAID: When any of the following occurs: 1) a RAID goes into a degraded
state, 2) a RAID is in a degraded state and will be deactivated (the alert
SNMP.
7
139