Turning Off The Computer - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

menu is displayed at the top of the screen. To navigate the menu and screen items,
follow the directions on the right of the screen.
The operating system and application programs initiate from the hard disk drive.
If your computer is attached to a network, the computer will begin attaching to
any LANs and remote applications to which you have access. A network
administrator can also "wake up" your computer (start it remotely) to download
programs or gather information about computer performance.

Turning off the computer

Turn off the computer as follows:
Statement 5:
CAUTION:
The power-control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power source.
v Press the power control button on the front of the computer. This starts orderly
v Press and hold the power control button for more than 4 seconds to cause an
v If you cannot use the power control button to turn off your computer,
Important: In some circumstances, the computer might not turn off immediately
10
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
shutdown of the operating system, if this feature is supported by your operating
system, and places the computer in standby mode.
Note: After turn off the computer, wait at least 5 seconds before you press the
power control button to turn on the computer again.
immediate shutdown of the computer and place the computer in standby mode.
You can use this feature if the operating system stops functioning.
disconnect the computer power cords from the electrical outlets.
Note: After disconnecting the power cords, wait approximately 15 seconds for
your computer to stop running.
when you press the power control button. If this happens, press and
hold the power control button until the computer turns off.