Power Supply - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

4. Disconnect the power/LED switch from the system board.
5. Disengage the lower tab of the power/LED switch by pressing upward on the
lower tab of the power/LED switch until it comes loose.
Note: It may be necessary to use the tip of a screwdriver to disengage the
lower tab.
6. Push inward on the two tabs of the top section of the power/LED switch until
it pops free of the chassis; then, remove it from the computer, making sure that
the cable follows freely.
7. To install the power/LED switch, reverse the previous steps.

Power supply

To remove the power supply, do the following:
Note: Read "Before you begin" on page 41 and the safety notices at "Safety notices
(multi-lingual translations)" on page 135.
1. Power-off the computer and remove external cables.
2. Remove the cover and support bracket (see "Side cover removal" on page 63
and "Support bracket removal" on page 64).
FRU information (service only)
99