Hard Disk Drive Installation - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

10. Slide the drive into the drive bay, and then attach the drive to the drive cage.
11. Connect one end of the diskette or IDE signal cable into the back of the drive
12. Connect the power cable to the back of the drive. The connectors are keyed
13. If you have other options to install or remove, do so now.
14. Replace the cover. See "Replacing the cover" on page 56 for details.
15. Reconnect the external cables and power cords; then turn on the attached
Hard disk drive installation: To replace a hard disk drive in the desktop model
computer, do the following:
52
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
and the other end of the cable into the diskette or IDE connector on the
system board. For the location of the diskette or IDE connectors, see "System
board internal cable connectors" on page 44.
Note: Make sure to route the signal cable so that it does not block the air flow
to the rear of the drives or over the microprocessor.
and can be inserted only one way.
devices and the computer.
1. Read the information in "Preinstallation steps" on page 51.
2. Turn off the computer and attached devices and disconnect the external cables
and power cords.
3. Remove the cover and frame support bracket. See "Removing the cover" on
page 45 and "Removing the frame support bracket" on page 46 for details.
4. Disconnect the power and signal cables from both drives in the drive cage.