Security U-Bolt Installation - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

2. Turn off the computer and all attached devices. Disconnect all external cables
and power cords; then remove the cover. See "Side cover removal" on page 63
for details.
3. Remove the support bracket. See "Support bracket removal" on page 64.
4. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the computer. Then remove the new DIMM from the
package.
5. Open the retaining clips and, if necessary, remove any existing DIMM.
6. Gently open the retaining clip on each end of the DIMM slot. Turn the DIMM
so that the pins align correctly with the connector.
7. Insert the DIMM into the connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the
DIMM is firmly seated in the connector.
8. If a gap exists between the DIMM and the retaining clips, the DIMM has not
been correctly installed. Open the retaining clips, remove the DIMM, then
reinsert it.
9. If you have other options to install or remove, do so now.
10. Replace the support bracket.
11. Replace the side cover, see "Replacing the cover" on page 77.
12. Reconnect the external cables and power cords, turn on the attached devices,
and then turn on the computer.

Security U-bolt installation

To help prevent theft, you can add a security U-bolt and cable to the computer.
This section discusses how to install a security U-bolt.
Do the following to install the U-bolt:
DIMM connector 1
DIMM connector 2
DIMM connector 3
Installing options
75