Adapter Installation - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

v For a list of supported options for the computer, refer to
Adapter installation: Do the following to install an adapter in the desktop model:
Attention:
damage from static electricity. For details on handling these devices, see "Handling
electrostatic discharge-sensitive devices" on page 134.
10. When you are ready, remove the adapter from the static-protective package. It
11. To install the adapter, carefully grasp the adapter by the top edge or upper
48
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
Sequence, and select Second device (SCSI) to designate the adapter
startup sequence. See "Configuration" on page 31 for details on using the
IBM Setup Utility program.
http://www.ibm.com/pc/support on the World Wide Web.
When you handle static-sensitive devices, take precautions to avoid
1. Review the information in "Safety information" on page 131.
2. Turn off the computer and attached devices.
3. Disconnect all external cables and power cords; then remove the cover. See
"Removing the cover" on page 45.
4. Determine which PCI slot you will use for the adapter.
Note: Check the instructions that come with the adapter for any requirements,
restrictions, or cabling instructions. It might be easier to route any
cables before you install the adapter.
5. Rotate each drive bay cage until the drive cage latches catch the front of the
computer chassis.
6. Lift the frame support bracket. See "Removing the frame support bracket" on
page 46.
7. Rotate the rear adapter support bracket to the open (unlocked) position and
remove it from the computer.
8. Remove the expansion-slot cover. From the rear of the computer, press on the
slot cover. Grasp it and pull it out of the expansion slot. Store it in a safe place
for future use.
Attention: Expansion-slot covers must be installed on all vacant slots. This
maintains the electronic emissions standards of the computer and ensures
proper ventilation of computer components.
9. Set any jumpers or switches on the adapter or system board as described by
the adapter manufacturer.
is best to move the adapter directly from the static-protective package to the
adapter slot. If this is not possible, set the adapter down in its static-protective
package on a hard surface. Avoid touching the components and gold-edge
connectors on the adapter.
corners, and align it with the expansion slot guides; then press the adapter