Small Computer System Interface Messages (Some Models); Diagnostic Programs And Error Messages - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

Small computer system interface messages (some models)

If the computer has an Ultra160 SCSI adapter installed and you receive a SCSI
error message when running the SCSISelect Utility program, refer to the following
table for actions to take if you receive an error message.
Note: If your system does not have a SCSI hard disk drive, ignore any message

Diagnostic programs and error messages

The system diagnostic programs are stored on the Device Drivers and IBM Enhanced
Diagnostics CD. These programs are the primary method of testing the major
components of the computer.
Diagnostic error messages indicate that a problem exists; they are not intended to
be used to identify a failing part. Troubleshooting and servicing of complex
problems that are indicated by error messages should be performed by trained
service personnel.
Sometimes the first error to occur causes additional errors. In this case, the
computer displays more than one error message. Always follow the suggested
action instructions for the first error message that appears.
The following sections contain the error codes that might appear in the detailed
test log and summary log, when running the diagnostic programs.
The error code format is as follows:
12
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
that indicates that the BIOS is not installed.
Table 1. SCSI messages
SCSI Description
Messages
All One or more of the following might be causing the problem.
v A failing SCSI device (adapter or drive)
v An improper SCSI configuration
v Duplicate SCSI IDs in the same SCSI chain
v An improperly installed SCSI terminator
v A defective SCSI terminator
v An improperly installed cable
v A defective cable
Action: Verify that:
v The external SCSI devices are turned on. External SCSI devices
must be turned on before the computer.
v The cables for all external SCSI devices are connected correctly.
v The last device in each SCSI chain is terminated properly.
v The SCSI devices are configured correctly.
If the above items are correct, run the diagnostic programs to obtain
additional information about the failing device.