Scsi Adapter Installation - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

10. If you have another adapter to install, repeat steps 1 on page 67 through 9. If
11. If you have installed a full-length adapter, rotate the front adapter support
12. Reinstall the rear adapter support bracket; then rotate the bracket to the closed
13. Replace the support bracket.
14. Replace the side cover, see "Replacing the cover" on page 77 for details.
15. Reconnect the external cables and power cords; then turn on the attached
SCSI adapter installation: Some models do not come with SCSI adapters. Do the
following to install an optional SCSI adapter:
1. If you do not have a preinstalled SCSI adapter, complete steps 1 on page 67
2. Connect the SCSI signal cable to the adapter and one or more of the signal
3. Connect the SCSI activity indicator cable to the adapter and to the SCSI LED
68
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
Attention: Be certain that the adapter is correctly seated in the expansion
slot before you turn on the computer. Incomplete installation of an adapter
might damage the system board or the adapter.
Expansion
slot cover
Rear
adapter
retention
bracket
9. Connect required cables to the adapter. Route cables so that they do not block
the flow of air from the fans.
you have another option to install, do so now.
bracket to the closed (locked) position.
(locked) position.
Note: The rear retaining bracket rests against the computer cover. You might
find it easier to lay the computer on its side to replace the cover.
devices and the computer.
through 9 of "Adapter installation" on page 66.
cable connectors to the rear of the SCSI devices.
connector (J35) on the system board. See "System board" on page 43 for the
Adapter
Front
adapter
retention
bracket