Fan; Power/Led Switch - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

Fan

To remove the fan, do the following:
1. Power-off the computer and remove external cables.
2. Remove the cover and support bracket (see "Removing the cover" on page 45
3. Remove the air baffle (see "Air baffle" on page 87).
4. Disconnect the fan cable from the system board.
5. For the desktop model, push in on the two tabs on the front of the chassis to
6. Pull the fan up and out of the chassis.
7. To install the rear fan, reverse the previous steps.

Power/LED switch

To remove the power/LED switch, do the following:
1. Power-off the computer and remove external cables.
2. Remove the cover and support bracket (see "Removing the cover" on page 45
3. Swing the CD-ROM drive cage up.
4. Disengage the lower tab of the power/LED switch by pressing upward on the
5. Push inward on the two tabs of the top section of the power/LED switch until
88
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
Note: Read "Before you begin" on page 41 and the safety notices at "Safety notices
(multi-lingual translations)" on page 135.
and "Removing the frame support bracket" on page 46).
release the fan.
Note: Read "Before you begin" on page 41 and the safety notices at "Safety notices
(multi-lingual translations)" on page 135.
and "Removing the frame support bracket" on page 46).
lower tab of the power/LED switch until it comes loose.
Note: It may be necessary to use the tip of a screwdriver to disengage the
lower tab.
it pops free of the chassis; then, remove it from the computer, making sure that
the cable follows freely.