10. Replace the cover. See "Removing the cover" on page 45.
11. Reconnect the external cables and power cords. Turn on the attached devices,
Security U-bolt installation
To help prevent theft, you can add a security U-bolt and cable to the computer.
Do the following to install the U-bolt:
1. Review the safety precautions listed in "Safety information" on page 131.
2. Turn off the computer and all attached devices. Disconnect all external cables
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the U-bolt through the rear panel; then attach and tighten the nuts.
5. Thread the cable through the U-bolt and around an object that is not part of or
6. Reconnect the external cables and power cords, and turn on the attached
Replacing the cover
Do the following to replace the computer cover:
1. Clear any cables that might impede the replacement of the cover.
2. Install the side cover by placing it into position on the computer, with the
56
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
9. Replace the frame support bracket.
and turn on the computer.
and power cords; then remove the cover. See "Removing the cover" on page 45
or "Side cover removal" on page 63 for details.
permanently secured to the building structure or foundation, and from which
the cable cannot be removed. Fasten the cable ends together with a lock. After
you add the security cable, make sure that it does not interfere with other
cables connected to the computer.
devices, then the computer.
notches on the underside of the cover matching up to the holes along the sides
of the computer. Press down on the cover release latch button as you close the