Port Side Led Activity For The Fcoe Converged Network Switch; Port Side Leds On The Fcoe Converged Network Switch - HP StorageWorks 8/40 - SAN Switch Hardware Reference Manual

Fan status

Port side LED activity for the FCoE Converged Network Switch

Figure 28 shows the port side of the FCoE Converged Network Switch. There are two port status LEDs
above each of the top row of ports. The left LED is for the top port; while the right LED is for the bottom
port. See Figure 7
1. System power LED
2. System status LED
3. Ethernet speed LED
Figure 28 Port side LEDs on the FCoE Converged Network Switch
Table 14 describes the port side LEDs and the recommended actions.
Indicates one of the following:
• Fan FRU is not seated cor-
rectly.
No light
• Fan FRU is not receiving
power.
Fan assembly I operating nor-
Steady green
mally.
Indicates one of the following:
• Fan FRU is not seated cor-
rectly.
• One or more of the fans in
the fan FRU has failed.
Steady amber (for
• The fan FRU was disabled
more than 5
by the user.
seconds)
NOTE:
When the switch is first
powered on, the fan status
LED shows amber until POST
has completed.
on page 25 for the locations of the GbE and FC ports.
Try one of the following:
•
•
No action required.
Try one of the following:
•
•
•
4. Ethernet link LED
5. CEE port status LED (port 0)
6. CEE port status LED (port 4)
8-Gb SAN Switch hardware reference manual
Verify that the fan FRU is
seated correctly.
Verify that the switch is
powered on.
Verify that the fan FRU is
seated correctly.
Verify that the fan FRU is en-
abled (use the fanEnable
command).
Replace the fan FRU.
65