Table of Contents
Advertisement
TFTP Server Address The IP address of the TFTP
server where the configuration file is located. This
entry is used only if the Firmware Update is set to
Enabled. If BOOTP Service (see the IP Configuration
screen under Configure IP Address on the System
Configuration menu) is set to Enabled, the address
will be obtained from the BOOTP server.
Firmware Update
Switch will try to look for a runtime image file over
the network. If set to Disabled, none of the fields
below have any effect.
File Name The pathname of the runtime image file
on your TFTP server to be downloaded.
Use Config File
config file during reboot.
Config File Name
to be downloaded.
System Utilities
The System Utilities menu features a Ping Test option. This
sends a Ping to test network connectivity between the
Switch and any other network device with an IP address.
Choose System Utilities on the main menu to access the
System Utilities menu seen below.
Using the Console Interface
Gigabit Ethernet Switch User's Guide
Determines whether or not the
Toggle to Enabled to download
The name of the configuration file
63
Advertisement
Table of Contents
