Table of Contents
Advertisement
If any item is found missing or damaged, please contact
your local D-Link reseller for replacement.
Setup
The setup of the Switch can be performed using the
following steps:
The surface must support at least 3 kg.
The power outlet should be within 1.82 meters (6 feet)
of the device.
Visually inspect the power cord and see that it is
secured fully to the AC power connector.
Make sure that there is proper heat dissipation from
and adequate ventilation around the Switch. Do not
place heavy objects on the Switch.
Desktop or Shelf Installation
When installing the Switch on a desktop or shelf, the rubber
feet included with the device must be first attached. Attach
these cushioning feet on the bottom at each corner of the
device. Allow enough ventilation space between the device
and the objects around it.
Unpacking and Setup
Gigabit Ethernet Switch User's Guide
7
Advertisement
Table of Contents
Need help?
Do you have a question about the DGS-3204 - Switch - EN 100VG-AnyLAN and is the answer not in the manual?