Dell 2135cn - Multifunction Color Laser Printer Troubleshooting Manual page 62

Values:
Auto Print* Automatically prints a fax activity report after every 50 incoming and outgoing fax communications.
No Auto Print Does not automatically print a fax activity report after every 50 incoming and outgoing fax communications.
Fax Transmit
Purpose:
To set whether to print a transmission result after a fax transmission.
Values:
Print Always Prints a transmission report after every fax transmission.
Print On Error* Prints a transmission report only when an error occurs.
Print Disable Does not print a transmission report after a fax transmission.
Fax Broadcast
Purpose:
To set whether to print a transmission result after a fax transmission to multiple destinations.
Values:
Print Always* Prints a transmission report after every fax transmission.
Print On Error Prints a transmission report only when an error occurs.
Print Disable Does not print a transmission report after a fax transmission to multiple destinations.
Fax Protocol
Purpose:
To set whether to print the protocol monitor report, which helps you identify the cause of a communication problem.
Values:
Print Disable* Does not print the protocol monitor report.
Print Always Prints a protocol monitor report after every fax transmission.
Print On Error Prints the protocol monitor report only when an error occurs.
System Settings
Use System Settings to configure the printer's power saving mode, warning tones, time-out duration, device display language, and job log auto print settings.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Power Saver Timer
Purpose:
To specify the time for transition to power saver mode.
Values:
Mode1
5min*
Specifies the time for transition to Power Saver Mode 1 and Power Saver Mode 2 in minutes.
5-60min
6min*
Mode2
1-6min
Enter 5 to put the printer in power saver mode five minutes after it finishes a job. This uses much less energy, but requires more warm-up time for the printer.
Enter 5 if your printer shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to operate with minimum warm-up time. Select a
value between 5 and 60 minutes for power save mode if you want a balance between energy consumption and a shorter warm-up period.