Specifying The Fax Settings; Changing The Fax Settings Options; Available Fax Settings Options - Dell 2135cn - Multifunction Color Laser Printer Troubleshooting Manual

1. Press until >SETUP appears, and then press
2. Press until >Admin Menu appears, and then press
3. Press until >Fax Settings appears, and then press
4. Press until >Ring Tone Volume appears, and then press
5. Press until the desired volume appears, and then press
6. Reboot the printer by turning the power switch off and then on again.
Specifying the Fax Settings

Changing the Fax Settings Options

1. Press until >SETUP appears, and then press
2. Press until >Admin Menu appears, and then press
3. Press until >Fax Settings appears, and then press
4. Press until the desired menu item appears, and then press
5. Use to find the status or use the number keypad to enter the value for the option you have selected.
6. Press to save the selection.
7. Press to return to the previous screen.
8. If necessary, repeat steps 4 through 7.
9. To return to the standby mode, press

Available Fax Settings Options

You can use the following settings options for configuring the fax system:
Option Description
You can select the default fax receiving mode.
Fax: (automatic receive mode)
l
Telephone (manual receive mode): Automatic fax reception is turned off. You can receive a fax by picking up the handset of the
l
external telephone and then pressing the remote receive code, or by setting OnHook to On (you can hear voice or fax tones from the
remote machine) and then pressing .
Telephone/Fax: When the printer receives an incoming fax, the external telephone rings for the time specified in Auto Rec Fax/Tel,
l
Receive
and then the printer automatically receives a fax. If an incoming call is not a fax, the printer beeps from the internal speaker indicating
Mode
that the call is a telephone call.
Ans Machine/Fax: The printer can share a telephone line with an answering machine. In this mode, the printer will monitor the fax
l
signal and pick up the line if there are fax tones. If the phone communication is using serial transmission in your country (such as
Germany, Sweden, Denmark, Austria, Belgium, Italy, France and Switzerland), this mode is not supported.
DRPD: Before using the Distinctive Ring Pattern Detection (DRPD) option, distinctive ring service must be installed on your telephone
l
line by the telephone company. After the telephone company has provided a separate number for faxing with a distinctive ring pattern,
configure the fax setup to monitor for that specific ring pattern.
Auto Rec Sets the interval at which the printer goes into the fax receive mode after receiving an incoming call. The interval can be specified within the
Fax range of 0 to 255 seconds. The default is 0 second.
Auto Rec Sets the interval at which the printer goes into the fax receive mode after the external telephone receives an incoming call. The interval can
Fax/Tel be specified within the range of 0 to 255 seconds. The default is 6 seconds.
Auto Rec Sets the interval at which the printer goes into the fax receive mode after the external answering machine receives an incoming call. The
Ans/Fax interval can be specified within the range of 0 to 255 seconds. The default is 21 seconds.
Line Monitor Sets the volume of the line monitor, which audibly monitors a transmission through the internal speaker until a connection is made.
.
.
.
.
.
.
.
.
.
.