Lpd Gateway Configuration; Network Configuration Settings; Ip Configuration; Dynamic Host Config Protocol (Dhcp) - Xerox 6100BD - Phaser Color Laser Printer System Manual

LPD gateway configuration

Network configuration settings

IP configuration

Dynamic Host Config Protocol (DHCP)

System Guide
If the manual mode is selected, the interface enables manual
entry and filtering for the Novell setups and printer queues.
In Gateways using the LPD (Line Printer Daemon) tab, the
administrator can enable or disable the LPD protocol, set the
default queue, and set the LPD port. The default port is 515,
the most commonly used port.
Within the System Administration part of the user interface a
Network configuration options are presented.
In Network Configuration, using the IP Address tab , the
administrator can enable or disable IP. If IP is enabled, the
administrator can adjust or change the following settings:
• IP Address
• Host name
• Subnet mask
• Default gateway
The administrator must also select the IP Configuration
Method. The drop down menu presents two options: a Static
IP configuration which allows the user to specify the IP
values, or DHCP method which allows a DHCP server to
provide IP information.
NOTE: The user is prompted whenever a reboot is required.
DHCP automates the configuration of computers using TCP/
IP and performs the following functions:
1. Automatically assigns IP Addresses.
2. Delivers TCP/IP stack configuration parameters like the
subnet masks and default gateway.
Gateway and Network Configuration
1-9