Xerox 6100BD - Phaser Color Laser Printer System Manual page 44

Backup and Restore
2-16
2. Check the SCSI ID selector and ensure that it is not set to
0, 1, 3 or 6. These settings could possibly conflict with
internal SCSI devices on some controller types. If there
are other external devices, ensure that no two devices are
set to the same SCSI ID.
NOTE: The SCSI device ID selector is a small window
with two small buttons, located on the back of the drive.
Press the buttons to change the value, if necessary.
3. Ensure that the tape inserted in the drive is a regular tape
and not a cleaning tape.
4. Power on the tape drive, and wait 10 seconds.
5. Power on the controller.
6. Press Stop + A as soon as the banner screen appears.
7. Ultra-SCSI devices only: Check that both green LEDs on
the back of the tape drive are lit.
8. At the ok prompt, enter boot -r to perform a
reconfiguration boot.
If problems recognizing the tape drive persist, call for service.
System Guide