VIII. ENVELOPE FEEDER
1. Removal of the External Covers
a. Rear Cover
1) Remove the screw and take off the rear
cover.
Screw
Rear cover
Figure 3-8-1
Note: Before performing an operation
check on the envelope feeder while
the rear cover is off, be sure to
either hold the bottom of the PCB
with your hand or tape it to the
frame.
b. Front Cover
1) Remove the screw and take off the front
cover.
Screw
Front cover
Figure 3-8-2
c. Lower Cover
1) Remove the rear and front covers.
2) Remove the two screws and dislodge
the lower cover.
Screws
Lower cover
Figure 3-8-3
CHAPTER 3
3 - 39