B. Hard disk (optional)
1. Removal from the video controller
PCB unit
1) Remove the video controller PCB unit.
2) Remove the connector.
3) Remove the 2 screws and slide the hard
disk out in the direction of the arrow.
Connector
Screws
Hard disk
Figure 3-7-4
C. DC Controller PCB
1) Remove the high-voltage power supply
unit following steps 1-2 on Page 3-36.
2) Disconnect the 18 connectors from the
DC controller PCB.
3) Remove the 4 screws and the mount
retainer, then take out the DC controller
PCB.
Connectors
Screws
Mount retainer
DC controller PCB
Figure 3-7-5
CHAPTER 3
3 - 33