Canon LBP 2460 - B/W Laser Printer Service Manual page 251

Message
63 ERROR CALL NVRAM (EEPROM) error.
FOR SERVICE
64 ERROR CALL SRAM in AIR chip error.
FOR SERVICE
32 DISK ERROR Hard Drive Failure - Write Error -
33 DISK ERROR Hard Drive Failure - Read Failure -
COLD RESET Displays when the COLD RESET (letter or
A4) Power-on sequence is selected.
COLD RESET A4 Displays when Factory Reset - A4 Power-on
sequence is selected.
COLD RESET LTR Displays when Factory Reset - LTR Power-
on sequence is selected.
CONTEXT SAVE Context Saving mechanism modified by OS.
ADJUSTED Displayed when printer powered on with
context saving enabled, but due to manual
recofiguration, there is not enough memory
to support it.
CONTEXT SAVE Context Saving mechanism modified by
CHANGE USER. Displayed when going online after
modifying context saving.
RESET TO SAVE RESET verification prompt. This message
will appear momentarily and then PAUSED.
When a menu item was changed before the
printer releases the port on which the last
job was processed, such as in the middle of
a job, or before the port timed out.
DSK FMT The operator has formatted the disk and the
RESTART operation has completed. The system will
now restart.
FLUSHING... A Reset operation has been performed by
the Operator in the middle of a job. The
current job is being flushed.
FORMATTING... This message displays when the disk is
being formatted.
I/O INITIALIZING This message displays when one of the
PSIO cards is being initialized.
This message may display if the upper tray
INSTALL UPPER.
is missing.
KEY NOT VALID Displays when a key is pressed that is not
Meaning
CHAPTER 4
Action
Turn the power OFF, then turn it
ON again. If it does not remedy
the problem, replace the
resident NVRAM.
Replace the video controller
PCB.
Replace the hard disk.
Replace the hard disk.
No action required although the
printer will be reset to its
factory defaults and any unique
settings will have to be reset.
No action required.
No action required.
Press CONTINUE key to
continue.
Press CONTINUE and printer
will reboot to enable its new
state.
Two options are available:
1. Press the reset key to enter
the RESET menu and save the
information immediately. This
will terminate the current job,
deleting temporary fonts,
macros and buffered data.
2. Press ONLINE and the
current job will resume where it
left off. The menu items
changed will not take effect
until the next end of job.
No action required.
The job that has been flushed
will have to be resubmitted.
No action required.
No action required.
Install the upper tray.
Press the correct button to
4 - 37