d. Fixing upper roller
1) Hold up the left and right levers in the
direction of the arrow.
2) Holdup the left and right envelope
levers.
3) Remove the 2 screws then remove the
separation upper guide while pulling out
the separation lower guide.
Fixing unit fastening levers
Envelope lever
Screws
Separation lower guide
Separation upper guide
Figure 3-6-10
4) Remove the E-ring and the spring, then
pull out the separation lower guide
toward you and slide it off in the
direction of the arrow.
E-ring
Spring
Separation lower guide
Figure 3-6-11
5) Remove the fixing roller heater
following steps 1-4 on Page 3-25.
6) Remove the thermoswitch following
steps 2 on Page 3-26.
7) Remove the thermistor following steps
2-3 on Page 3-26.
8) Remove the screws and diode holder.
CHAPTER 3
3 - 27