b. Rear wire
1) Insert the pulley alignment pin in the left side(looking from the front) of the shaft.
2) Wind the wire one and a half times starting from the second groove from the front of pulley 2
and insert it on to the shaft.
3) Wind the wire one and a half times starting from the second groove from the back of pulley 1
and insert it on to the shaft.
4) Secure the pulleys with the E-ring.
Shaft
Pulley alignment pin
Wires
Pulley 2
Pulley 1
E-ring
Figure 3-11-43
CHAPTER 3
3 - 67