CHAPTER 3
b. Thermoswitch
1) Remove the wire cover.
2) Remove the 4 screws and then the lead
wire and the thermoswitch.
Screws
Thermoswitch
Figure 3-6-7
3 - 26
c. Thermistor
1) Remove the wire cover.
2) Disconnect the connector and remove
the cable from the fixing left cover.
Connector
Figure 3-6-8
3) Remove the screw and the thermistor.
Screw
Thermistor
Figure 3-6-9
<Note on reassembly>
When installing the thermistor, ensure that
its detection surface is uniformly contacting
the fixing upper roller surface.
If it is not making an uniform contact, check
that the plate spring has not deformed.