CHAPTER 3
D. Pick-up PCB
1) Remove the pick-up unit following steps
1-7 on Page 3-12.
2) Disconnect the 6 connectors.
3) Remove the screw, disconnect the 2
claws, and take out the pick-up PCB.
Connectors
Screw
Claw
Pick-up PCB
Figure 3-7-6
3 - 34
E. Multi-purpose Tray PCB
1) Remove the manual feed pick-up unit
following steps 1-6 on Page 3-17.
2) Remove the manual feed drive unit
following steps 1-4 on Page 3-18.
3) Disconnect the connector.
4) Remove the screw and disconnect the
claw. Then take out the multi-purpose
tray PCB.
Connector
Screw
Claw
Multi-purpose tray PCB
Figure 3-7-7