List Of Error Codes - Brother ZE-855A Instruction Manual

16. TROUBLESHOOTING
16. FEHLERSUCHE
16. RESOLUTION DES PROBLEMES
16. LOCALIZACION DE AVERIAS

16-3. List of error codes

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall
outlet before opening the face plate of the control box. Touching areas where high voltages are present can
result in severe injury.
Turn off the power switch and disconnect the power cord before carrying out troubleshooting, otherwise the
machine will operate if the treadle is pressed by mistake, which could result in injury.
If an error code appears in the LED display on the operation panel, check the error code and then turn off the power.
(However, the error display will not disappear immediately when the power is turned off.)
After the panel display turns off, remove the cause of the error and then turn the power back on. (Except for error
Display
Needle zigzag position cannot be
found.
Zigzag motor overcurrent
Overheating of control circuit
board heata sink
Exhaust fan problem
Inside air recirculation fan prob-
lem
Memory element problem
Needle zigzag data problem
Communication problem
between CPUs
Version mismatch
Machine motor IC problem
Power supply voltage abnormal-
ity (high)
Power supply voltage abnormal-
ity (low)a
Machine motor locked
209
Details
Malfunction of home position sensor or harness
Malfunction of zigzag motor or harness
Malfunction of control circuit board
Zigzag mechanism operation is heavy
Malfunction of zigzag motor or harness
Malfunction of control circuit board
Malfunction of cooling fan
Blocked air inlet in control box
Malfunction of control circuit board temperature sensor
Malfunction of right-side fan (when looking from the rear) or har-
ness
Malfunction of left-side fan (when looking from the rear)
or harness
Malfunction of control circuit board
Malfunction of P-ROM or poor connection
Problem with custom data
Malfunction of control circuit board
Noise affecting transmission
Malfunction of control circuit board or P-ROM version does not match
Mismatch between control circuit board and P-ROM versions
Blocked air inlet in control box
Malfunction of machine motor or harness
Malfunction of power supply circuit board
Power supply voltage is too high
Power supply voltage is too low
Timing belt is not fitted
Loose pulley
Load too great during sewing
Malfunction of synchronizer or harness
Motor temperature protection function has operated.
ZE-855A,856A
DANGER
CAUTION
(If the motor's serial number is "G03xxxxxx" or later)
Cause
A AAA)