List Of Error Codes - Brother BAS-311H Service Manual

11. LIST OF ERROR CODES

11. LIST OF ERROR CODES
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the control box cover. Touching areas where high voltages are present can result in severe injury.
If a malfunction should occur with the sewing machine, a buzzer will sound and an error code will appear in the display
window. Follow the remedy procedure to eliminate the cause of the problem.
Warnings displayed as symbols
Code
The start switch was pressed without the work clamp being lowered.
CLdn
First lower the work clamp.
The needle bar is not stopped in the needle up stop position.
UP
Turn the pulley until the point where the error display disappears.
Switch-related errors
Code
The STOP switch was pressed.
E010
Press the RESET key to clear the error.
The STOP switch was pressed.
E011 Press the RESET key to clear the error.
Press the ▼ key to move the feed mechanism so that you can continue sewing.
The STOP switch was pressed.
E012
Press the RESET key to clear the error, and then depress the start switch to move the feed mechanism to the
home position.
The stop switch was still being pressed when the power was turned on, or there is a problem with the stop switch
E015 connection.
Turn off the power, and then check that connector P9 on the main P.C. board is properly connected.
Problem with the stop switch connection.
E016
Turn off the power, and then check that connector P9 on the main P.C. board is properly connected.
Start switch was being depressed when power was turned on.
E025 (For a foot switch, the foot switch was being depressed to the 2nd step.)
Turn off the power and check the foot switch.
Work clamp switch was being depressed when power was turned on.
E035 (For a foot switch, the foot switch was being depressed to the 1st step.)
Turn off the power and check the foot switch.
Machine head tilting was detected after the power was turned on.
E050
Turn off the power, and then return the machine head to its original position.
Check that connector P14 on the main P.C. board is properly connected.
Machine head tilting was detected while the sewing machine was operating.
E051
Turn off the power, and then check that connector P14 on the main P.C. board is properly connected.
Machine head tilting was detected when the power was turned on.
E055 Turn off the power, and then return the machine head to its original position.
Check that connector P14 on the main P.C. board is properly connected.
An operation panel key was still being pressed when the power was turned on, or key is faulty.
E065
Turn off the power and check the operation panel.
141
DANGER
Cause of error and remedy
Cause of error and remedy
BAS-311H