Using A Cycle Program - Brother RH-9800 Instruction Manual

7. SEWING

7-6. Using a cycle program

This example shows the procedure for a cycle program which runs program 1 (with the knife operating) three times and
program 3 (with the knife not operating) once.
(2)
(K)
(1)
1177Q
* If you want to clear a cycle program, carry out steps 1. and 2. above and then press the RESET button. Then press the
MODE button (1) to switch to automatic mode.
36
Programming procedure
1173Q
1. Press the MODE button (1) to switch to programming
mode.
2. Keep pressing the SELECT button (2) until " C "
appears in the program number display window.
* The number in the thousands column of the front
panel display (J) will start flashing at this time.
3. Press the "Up" button (L) or the "Down" button (K) to
change the value in the thousands column to "1", and
then press the ENTER button (N).
* Program number 1 will now be set, and the dot in
the thousands column will flash.
(1)
4. Change the flashing interval so that the illumination
time for the dot is longer than the switched-off time.
* Press the "Up" button (L) to make the illuminated
period longer, and press the "Down" button (K) to
make the illuminated period shorter.
5. Press the ENTER button (N).
(J)
* The dot in the thousands column will illuminate
1174Q
steadily and the number in the hundreds column
will start flashing.
(L)
* When the dot is illuminated, the knife will operate,
and when the dot is switched off, the knife will not
operate. However, if the OFF indicator illuminates
(N)
during sewing, the knife will not operate even if the
dot is illuminated.
1175Q
6. Repeat steps 3. to 5. for the hundreds and tens
columns.
7. Press the "Up" button (L) or the "Down" button (K) to
change the value in the units column to "3", and then
press the ENTER button (N).
* Program number 3 will now be set, and the dot in
the units column will flash.
8. Change the flashing interval so that the illumination
time for the dot is shorter than the switched-off time,
and then press the ENTER button (N).
* The dot in the units column will switch off and the
number in the thousands column will start flashing.
9. Press the MODE button (1) to switch to automatic
mode. The cycle program "1.1.1.3" will then be set.
1176Q
RH-9800