Table of Contents
Advertisement
6. USING THE OPERATION PANEL AND FRONT PANEL
G. Setting the number of eyelet stitches
(K)
1146Q
H. Setting the cutting space
(K)
1148Q
I. Setting the knife position compensation
(K)
1150Q
24
1. The number of eyelet stitches can be set to between 4
and 20 stitches in steps of 1 stitch.
2. Press the "Up" button (L) or the "Down" button (K) to
set the desired number of eyelet stitches.
* When the setting value is being changed, the
(L)
numerals appearing in the display will flash.
3. Press the ENTER button (N) to accept the new eyelet
stitch number setting.
(N)
* The display will stop flashing.
1147Q
1. The cutting space can be set to between -0.3 and 0.5
mm in steps of 0.1 mm.
Note: You cannot set the cutting space to a value
that would make the difference between the
knife position compensation and the cutting
(L)
space less than -0.7 mm.
2. Press the "Up" button (L) or the " Down" button (K) to
(N)
set the desired cutting space.
* When the setting value is being changed, the
1149Q
numerals appearing in the display will flash.
3. Press the ENTER button (N) to accept the new cutting
space setting.
* The display will stop flashing.
1. The knife position compensation can be set to
between -0.7 and +0.7 mm in steps of 0.1 mm.
* If you would like to move the knife closer to the
seam, set to a negative value; if you would like to
move it away from the seam, set to a positive value.
(L)
Note: You
compensation to a value that would make the
difference
(N)
compensation and the cutting space less than
-0.7 mm.
1151Q
2. Press the "Up" button (L) or the "Down" button (K) to
set the desired knife position compensation.
* When the setting value is being changed, the
numerals appearing in the display will flash.
3. Press the ENTER button (N) to accept the new knife
position compensation setting.
* The display will stop flashing.
RH-9800
cannot
set
the
knife
between
the
knife
position
position
Hide quick links:
Advertisement
Table of Contents
