Selecting A Program Number; Changing The Mode; Changing The Cutting Timing - Brother RH-9800 Instruction Manual

6. USING THE OPERATION PANEL AND FRONT PANEL
If the power is turned on and the RESET switch is then pressed, the feed bracket will move to the cloth setting position.
Operations such as selecting a program number, changing the operation mode and selecting the cutting method can
then be carried out.

6-2. Selecting a program number

A maximum of nine different eyelet shapes can be programmed.

6-3. Changing the mode

6-4. Changing the cutting timing

20
1. Press the PROGRAM NUMBER button (1). (Check
(2)
(1)
1128Q
1. Press the MODE button (1).
(1)
1019Q
When "BEFORE" (cutting before sewing) is selected, the
knife operates before the buttonhole is sewn.
When "OFF" (no cutting) is selected, the knife does not
operate.
When "AFTER" (cutting after sewing) is selected, the
knife operates after the buttonhole is sewn.
1. Press the KNIFE button (1).
(1)
1129Q
RH-9800
which of the mode indicator illuminates.)
In automatic, feed or manual mode, the program
numbers are displayed in the program number
display window (2) in the following order each time
the button is pressed.
1 2 9
Note: If cycle programs have been input, the
sequence will be as follows:
1 2
( indicates a cycle program.)
* In programming mode, the program numbers are
displayed in the program number display window
(2) in the following order each time the button is
pressed.
1 2 9
* The mode changes in the following order each time
the button is pressed.
AUTO FEED MANUAL
Automatic mode is used for normal sewing.
Feed mode is used to move the feed bracket with
out sewing in order to check component positions.
Use the Manual mode to check the machine
operation when sewing by turning the upper shaft
pulley by hand.
Programming mode
programs.
* The cutting timing changes in the following order
each time the button is pressed.
BEFORE OFF
9
C
PROGRAM
is used when setting
AFTER