Page of 2

HP 4400 Replacement Instructions

Hp storageworks disk enclosure fan module replacement instructions.
Hide thumbs
   
HP Disk Enclosure Fan Module
© Copyright 2009–201 1 Hewlett-Packard Development Company, L.P.
Printed in Puerto Rico
Part number: 5697-0978
Published: June 201 1
Edition: Third
*5697-0978*
For the latest documentation, go to
support/manuals, and select your product.
The information contained herein is subject to change
without notice. The only warranties for HP products and
services are set forth in the express warranty statements
accompanying such products and services. Nothing
herein should be construed as constituting an additional
warranty. HP shall not be liable for technical or editorial
errors or omissions contained herein.
WARRANTY STATEMENT: To obtain a copy of the
warranty for this product, see the warranty information
website:
http://www.hp.com/go/storagewarranty
Observe the following precautions when replacing a fan
module.
CAUTION:
changes the air flow within the enclosure. Both fan
modules must be installed for the enclosure to cool
properly. If a fan module fails, leave it in place in
the enclosure until a new fan is available to install.
Parts can be damaged by electrostatic discharge.
Use proper anti-static protection. Refer to the
documentation that shipped with your system for
additional information.
NOTE:
Port-colored (purple) latches on
components like the fan module means the
component is hot-swappable. It can be removed
and replaced without having to power the system
down.
There are two fan modules on the back of the disk
enclosure. See
locations.
Figure 1 Fan module locations
1. Fan 1
Page 1
http://www.hp.com/
Removing a fan module significantly
Figure 1 (page 1)
for the
2. Fan 2

Advertising

   Also See for HP 4400

   Related Manuals for HP 4400

   Summary of Contents for HP 4400

This manual also for:

6400/8400

Comments to this Manuals

Symbols: 0
Latest comments: