Set Vpgroups - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

set VPGroups

Enables or disables the virtual port groups (VP groups), and specifies names to each VP group.
VpGroup 1 cannot be disabled; however, you can change its name.
Session: admin
Example:
MPX200 <1> (admin) (miguser) #> set vpgroups
The following wizard will query for attributes before persisting
and activating the updated mapping in the system configuration.
If you wish to terminate this wizard before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Configuring VpGroup: 1
-------------------------
Status (0=Enable, 1=Disable)
VpGroup Name (Max = 64 characters)
All attribute values for VpGroup 1 that have been changed will now be saved.
Configuring VpGroup: 2
-------------------------
Status (0=Enable, 1=Disable)
VpGroup Name (Max = 64 characters)
All attribute values for VpGroup 2 that have been changed will now be saved.
Configuring VpGroup: 3
-------------------------
Status (0=Enable, 1=Disable)
VpGroup Name (Max = 64 characters)
All attribute values for VpGroup 3 that have been changed will now be saved.
Configuring VpGroup: 4
-------------------------
Status (0=Enable, 1=Disable)
VpGroup Name (Max = 64 characters)
All attribute values for VpGroup 4 that have been changed will now be saved.
[Enabled ]
] VPGroup 1
[VPGROUP_1
[Enabled ]
] VPGroup 2
[VPGROUP_2
[Enabled ]
] VPGroup 3
[VPGROUP_3
[Enabled ]
] VPGroup 4
[VPGROUP_4
MPX200 Multifunction Router 303