Mpx200 Log Data; Mpx200 Statistics; Mpx200 Ping Command; Using Hp Command View Eva To Locate A Hardware Device - HP StorageWorks 6100 - Enterprise Virtual Array User Manual

• In HP Command View EVA, select the General tab, and then click the Locate button. Use the Locate
ON and Locate OFF buttons to control the blue LED
Figure 83 Using HP Command View EVA to locate a hardware device
.

MPX200 log data

The MPX200 maintains a log that can be displayed through the CLI. The log is persistent through
reboots or power cycles. To view the log, use the CLI command show logs.
See Table 27 on page 209,

MPX200 statistics

Statistics for the iSCSI and Fibre Channel ports are available through the CLI. To view statistics, use
the CLI command show stats.

MPX200 ping command

The ping command is the most basic network troubleshooting tool that is available to troubleshoot
FCIP route problems. This command runs a diagnostic in which a message is sent to a destination,
the destination echoes a reply, and the command returns the amount of time it took to reach the
destination and back.
For troubleshooting an intermittent FCIP link run the ping command for an extended period of time,
recording the output. The output should be evaluated looking for large deviations in the ping-time or
lost-packets. Also use the maximum packet-size for the ping test; using the 56-byte default packet
size is not a typical packet size using for FCIP.
130 Diagnostics and troubleshooting
Table 28 on page 227, and
Figure 84
(Figure 83).
Table 29 on page 230 for log data descriptions.
illustrates the ping command.