4.16 ODD/SD board
4.16 ODD/SD board
Removing the ODD/SD board
To remove the ODD/SD board, follow the steps below and refer to Figure 4-22 to 4-24.
1. Disconnect the FP cable carefully from the connector CN9800 on the system board.
2. Disconnect the SD cable from the connector CN9700 on the system board.
3. Stand the ODD and remove the following screws.
• M2×3C
4. Slide the SD board outside and lift up the SD board and ODD to remove. (SD cable
is fixed to the middle frame by the double-sided tape.)
M2x3C S-THIN
HEAD
SD board
PORTÉGÉ R500 Maintenance Manual (960-634)
S-THIN HEAD
ODD
Double-sided tape
Guide
Figure 4-22 Removing the ODD/SD board (1)
4 Replacement Procedures
×2
CN9700
CN9800
[CONFIDENTIAL]
FP cable
SD cable
4-39