Procedure 2 Partition Check - Toshiba Portege R500 Maintenance Manual

2 Troubleshooting Procedures
Procedure 2 Partition Check
Insert the Toshiba DOS system disk and restart the computer with U key holding down.
Perform the following checks:
Type C: and press Enter. If you cannot change to drive C, go to Check 2. If you
Check 1
can change to drive C, go to Check 3.
Type FDISK and press Enter. Choose Display Partition Information from the
Check 2
FDISK menu. If drive C is listed, go to Check 3. If drive C is not listed, return to
the FDISK menu and choose the option to create a DOS partition on drive C.
Restart the computer from the Toshiba MS-DOS system disk. If the problem still
exists, go to Procedure 3.
Check 3 If drive C is listed as active in the FDISK menu, go to Check 4. If drive C is not
listed as active, return to the FDISK menu and choose the option to set the active
partition for drive C. Restart the computer and then go to Procedure 3.
Check 4 Remove the FD and restart the computer. If the problem still exists, go to
Procedure 3.
Check 5 Using the SYS command on the Toshiba DOS system disk, install system files on
the HDD.
If the following message appears on the display, the system files have been
transferred to the HDD. Restart the computer. If the problem still exists, go to
Procedure 3.
System transferred
NOTE: If the computer is running Windows 2000, OSR2 or higher and the hard disk has
more than 512 MB capacity, the FDISK program will ask if you need support for
a partition larger than 2GB. Select Y for large partition support; however, be
sure to read the precaution regarding access by other operating systems.
2-36 [CONFIDENTIAL]
2.6 HDD Troubleshooting
PORTEGE R500 Maintenance Manual (960-634)