Setting Of The Hardware Configuration - Toshiba Portege R500 Maintenance Manual

3.3 Setting of the hardware configuration

3.3 Setting of the hardware configuration
To execute this program, 2, Repair Initial config set and press Enter in the startup menu,
press Enter and follow the directions on the screen. The H/W initial information setting tool
consists of four subtests. Move the highlight bar to the subtest you want to execute and press
Enter.
NOTE: Connect USB FDD, when you perform the DIAGNOSTIC PROGRAM from the
CD-ROM. DMI information on the subtest 03 is written in floppy disk.
Subtest 1 Initial configuration
This subtest executes the following items and shows their contents in the
display. When an item ends normally, the program proceeds automatically to
the next one. When an error is found, the program stops and waits for key
input. (After solving the problem, the program executes the item again.)
• Setting of the CPU set table
• Setting of the micro code
• Setting of the EHSS
• Inputting and writing of DMI information
When the DMI information is displayed, the following messages appear in
order. Input each information. (If you do not replace the PCB, the DMI
information should not be changed.)
1. "Enter Model Name ?" is displayed. Input the computer's model
name and press Enter. (e.g. DynaBook)
2. "Enter Version Number ?" is displayed. Input the computer's
version number and press Enter.
(e.g. PC18070C313S)
3. "Enter Serial Number ?" is displayed. Input the computer's serial
number and press Enter. (e.g. 12345678)
4. "Enter Model Number ?" is displayed. Input the computer's sales
model number and press Enter. (e.g. PP200-AAAAA)
5. "Enter Bundle Number ?" is displayed. Input the computer's
PCN/Bundle number and press Enter.
(e.g. PMSREQ3Q34H/S0123456789)
6. "Write data OK (Y/N) ?" is displayed. To write the DMI
information to the Flash ROM, press Y, and then Enter.
PORTEGE R500 Maintenance Manual (960-634)
3 Tests and Diagnostics
[CONFIDENTIAL] 3-9