Remote Control Card - HP D7171A - NetServer - LPr Manual

Chapter 6 Addendum

Remote Control Card

The HP TopTools Remote Control card must be in slot 2 and requires a cable connection to I/O baseboard. The
TopTools Remote Control cable connects to the I
use of the Remote Control card, see Server Management for the LXr 8000. See Figure 6-2.
Use the Non-Hot-Plug Board Installation procedure to install the HP TopTools Remote Control card into the I/O
baseboard slot.
NOTE The cable for the HP TopTools Remote Control card must be connected to the I
J1D1, on the I/O baseboard.
PG10-P9
+3.3 VDC
33/66 Mhz
2
C connector J1D1 on the I/O baseboard. For more information on
10 9 8 6 5
7
P8-P7 P6-P3
+3.3 VDC +5 VDC
33/66 Mhz 33 Mhz
(includes
Programmable
Interrupt
Device)
Figure 6-2. NetServer I/O Baseboard
HP NetServer LXr 8000 Installation Guide
4 3 2 1
P2-P1
+5 VDC
33 Mhz
(Primary PCI bus,
includes SCSI, video,
and IDE/ISA bridge)
2
C connector,
5