HP D7171A - NetServer - LPr Manual page 15

Pci card installation and replacement and hot-plug operations

Hide thumbs Also See for D7171A - NetServer - LPr:

Chapter 6 Addendum

3. If Unsupported appears under Board in the utility's window instead of the desired PCI board, one of the

following conditions might be true:

The PCI Hot-Plug board is not supported by a hot-plug compliant software driver.

The software driver for the PCI Hot-Plug board is not properly installed and loaded. See Windows NT

Help for loading drivers.

The PCI board may be defective.

NOTE

If you have a board without a hot-plug compliant driver in one of the hot-plug slots, the board will

show up on the interface utility as unsupported, but the interface will not allow you to power down

the slot.

4. Identify the physical location of the desired PCI Hot-Plug board, using the PCI Hot-Plug Utility and

Figures 6-9 and 6-10.

Figure 6-8. PCI Hot-Plug Utility

HP NetServer LXr 8000 Installation Guide

Table of Contents