HP D7171A - NetServer - LPr Manual page 27

Pci card installation and replacement and hot-plug operations

Hide thumbs Also See for D7171A - NetServer - LPr:

Chapter 6 Addendum

PowerIng Up the PCI Slot

Use this procedure to apply power to a hot-plug slot only after replacing an existing PCI Hot-Plug board with an

identical PCI Hot-Plug board.

1. If not already open, select the PCI Hot-Plug Utility from the Programs menu.

2. Left-click the PCI slot (Slot 9) with the Not Ready status.

3. Click the Power button in the upper right of the menu. See Figure 6-19.

A pop-up prompt appears asking you to confirm your choice.

See Figure 6-20.

You may also right-click the selected slot (slot P9) and the pop-up prompt appears.

Figure 6-19. PCI Hot-Plug Utility – Turn Power On

HP NetServer LXr 8000 Installation Guide

Table of Contents