HP D7171A - NetServer - LPr Manual page 12

Chapter 6 Addendum
14. Align the board along its slot and position it in the slot.
15. Push the board down into its connector on the I/O baseboard.
16. Insert the screw in the accessory board's bracket and secure it to the HP NetServer's rear panel.
See Figure 6-6.
17. If the installed accessory board requires a connection to the I/O baseboard, system board, or chassis, ensure
that the cable is properly attached.
Refer to the accessory board documentation for connection requirements.
18. If all desired accessory boards have been installed, re-install all covers.
CAUTION
To prevent damage to cables, or a disruption in service due to a disconnection of cables, use
caution when sliding the chassis into the rack.
19. If chassis work is complete, slide it back into the rack. See Figure 6-7.
20. Use a T-25 screwdriver to screw the flanges to the rack front columns. See Figure 6-7.
21. Re-install the bezel onto the front of the NetServer.
10
Figure 6-6. Installing the Accessory Board
HP NetServer LXr 8000 Installation Guide