HP D7171A - NetServer - LPr Manual page 20

Chapter 6 Addendum
Removing a PCI Hot-Plug Board
Use this procedure to physically remove a PCI Hot-Plug Board from the slot.
1. At the front of the NetServer, extend the anti-tip foot out of the installation rack. See Figure 6-14.
2. Remove the bezel from the front of the NetServer.
3. Use a T-25 screwdriver to remove the screws holding the NetServer's flanges to the rack front columns.
CAUTION
To prevent damage to cables, or a disruption in service due to a disconnection of cables, check
for short cables at the rear of NetServer and disconnect before proceeding.
4. Extend the NetServer chassis from the rack.
18
Rack front columns
Use anti-tip foot
Use handle to
pull out NetServer
Figure 6-14. Sliding the NetServer out of the Rack
HP NetServer LXr 8000 Installation Guide
Flanges